The pledge of clean and fresh linen is not only a powerful washing machine machine, but also high-quality tools for washing. A good washing powder allows us to support things in perfect condition and, moreover, it does not harm the inner device of the washing machine.
Sometimes the hostesses face such a problem: after washing from the drum, they take out wet, squeezed, but absolutely not stressed underwear with the remaining stains and an unpleasant smell. The reason for this is detected quickly: it is enough just to open the feeder of the washing powder and you will see that the washing tools remained intact.
About what to do if such a trouble happened to your washing machine, read in today's article.
How should the process occur?
To download the washing powder and air conditioner, a special container consisting of several compartments is provided, each of which is used at a certain stage - when soaking, washing, or rinsing. To each of the compartments, the hose of the filler valve is supplied through which water flows and "takes" the tool. Next, through the hose powder enters the tank.
The features of this system depend on the model of the washing machine. Older devices are equipped with only one bay valve, which alternately sends the water stream into each of the compartments. Modern units operating under the control of the electronic module are equipped with several valves, each of which serves water into its compartment.
Most often is that the tools for washing remain in the feeder, the failed drain valve is to blame. Read more about different types of breakdowns below.
Should the powder completely wash off?
If you correctly calculated the dosage (recommendations are usually indicated in the instruction manual of the washing machine), then ideally the powder should disappear from the feeder to the end of the washing, with the exception of a small amount of means that can be clogged into the angle of the container.
Article on the topic: Mats for water heating floor: Features of choice and installation
Powder can stay in the feeder if you fall asleep it much more than it was required for this washing mode. In addition, poor-quality washing products are poorly washed out of the feeder, which slowly dissolve in water. If you have noticed that the powder is knocked in lumps and sticks to the walls of the container, most likely, the cause is in this.
Thus, before disassembling the washing machine in search of faulty parts, make sure that it is not an exceedable quantity or improper quality of washing.
Causes of problems and ways to eliminate it
Cause | What happened? | What to do? |
Converted toxic powder feeder compartments | The tool for washing is loaded into the container compartment, which is not activated when the washing program is selected (for example, in the compartment, which is used for pre-soaked) | Carefully read in the user manual Description of this wash program; Examine the design of the washing powder feeder |
Weak Water Pressure in Pipes | Water pressure may vary as a result of preventive work or if the water constipation valve is not open until the end | Check the pressure by opening the crane of the cold water supply; If the pressure is weak, make sure that the water is fluent in the pipes, then contact the HSEK |
Toward of the filling filter | The filter has been hammered by small garbage, remnants of detergents or lime slices | Disconnect the bulk hose from the machine, immediately behind it you will find a metal mesh - this is a filter; Carefully remove it and clean the brush under the jet of water |
Fault of the filler valve | Failed the filler valve, which is responsible for the supply of water to the washing powder dispenser | Check the performance of the filling valve using a multimeter; If it is faulty, it must be replaced (more about this in the article "The washing machine is gaining water in the off state") |
Malfunction of the nozzle | The nozzle through which water flows into the dispenser of the washing powder, can clog out because of too tight or dirty water; In addition, a grinding rope can be damaged | Repair and cleaning nozzles are engaged in service centers; You can also call the repairman's house |
Article on the topic: Penage door do it yourself: Installation Recommendations
Another problem impedes the normal exit of the conditioner for linen from the container is a plot of a drain compartment. About what should be done in this case, see the next video.