Most of those who make the repair, to finish the walls, chooses wallpaper. The popularity of this finishing material is explained by a large variety of colors and textures, so that the room acquires the desired appearance. Those who invite special masters for salary do not have the need for the knowledge of the process itself. Well, those who choose independent work should take into account a number of important rules, and familiarize themselves with them best before the start of the work itself.
Many of those who decided to perform a stick on their own, are interested in questions about how it should be done correctly, but in particular where to start glue the wallpaper in the room. So let's focus on these issues.
Choosing the desired materials and tools
It is important to make the right measurements.
So, before you know whether it is necessary to glue the wallpaper from the window or from the door, let's briefly focus on the main preparatory moments and on what tools we need.
First of all, you need to choose the type of wallpaper, calculate their right amount and pick up a certain glue. All this can be done directly in the store, contacting the consultants to sellers. Calculating the number of rolls and glue, you should always round down in the direction of magnification, especially when the wallpaper is selected with a pattern (consumption may increase by 20%).
Usually use the following tool:
- Capacity for glue breeding;
- scissors;
- brush and pencil;
- putty knife;
- plumbing and roulette;
- Rubber roller.
Rules of gluing wallpaper
The result of the salary should never disappoint
It does not matter where work will be carried out, in the kitchen, in the hallway or in the corridor. You will need to perform a number of conditions. Before starting work, you need to prepare the room, remove the furniture and close the room with a film. The walls themselves should be cleaned from old coatings, aligned and covered with primer.
Before cut off the cloth, you need to measure the required height and add a small supply to it. The measurement process can be performed both with the help of a roulette and directly web. In the second case, it will not work independently to measure the canvas, so it will have to work together.
Sliced leather is washed with glue, paying special attention to the edges, after which they leave the web for impregnation. In some cases, the glue can be missed and the surface of the wall. It is impossible to leave the missing canvas for a long time, otherwise it will be unsuitable for work.
Article on the topic: How to sew a lambrene with your own hands?
When applying the canvas on the wall, the lower edge fell to eliminate the drawing of it on the floor, and then transferred to the wall and glued. For dense fit, the canvas smoothes with brushes by the movements diagonally. All excess glue and the resulting air bubbles are removed.
Where to glue wallpaper
Photo: Start of work depends on many factors
Even before sticking, you need to decide where to start glue wallpaper. When choosing a method usually proceed from the type of lighting. A few decades ago, the wallpaper was glued only to the mustache, and the canvas themselves had a strip on which the next canvas had to be glued. Well, so that the transition is not noticeable, glued to glue from the window.
Today, in everyday life, different ways of pasta, so you choose where it is better to start glued wallpaper not so relevant. Well, if it is used dense wallpaper, they are not recommended to glue the flame at all, therefore, a popular previous method "from the window" for them is completely contraindicated.
What are the options for salary today?
- From the door - with the vertical cracking of the walls, it is necessary to observe a strict verticality, and therefore work can be started at any suitable vertical reference (door jamb, window slope, etc.). The very first web should be strictly strictly strictly vertically, for which you can use special additional devices (plumbing), after which the accumulation process continues sequentially in the selected direction.
- From the angle - this method is suitable only if the corners are perfectly smooth. But since this condition is observed in rare cases, then the most responsible bands are best to stick at their usual landmarks.
- From a major reference - if the room has many passes, windows, then the process of salary is better to start from the largest reference.
- From several lines - this method is used if a large window is provided in the room and the salary occurs in different directions from it. So that the docks are cloths are less noticeable, it is better to do them above the windows and a door.
Article on the topic: Room design 20 sq m in one-room apartment
How to keep the vertical in uneven corners
Photo: Properly selected drawing - half work
Special attention should be paid to the rules for watches wallpaper with a closed geometric pattern. And if the corners are uneven, then no matter how the method is not used, it is possible that the verticality will be lost. As soon as there is a meeting with the first glued web, then it will not only be very difficult to docile the pattern, but in some cases it is not even possible.
Specialists offer in this case to use one effective method - when each of the walls can use a new vertical line. In this case, the last cloth on each of the walls will go for a couple of centimeters to a new one.
Such a non-ideal docked with cavities will result in a more aesthetic look of the room. Use this method can be used exclusively on thin wallpaper. As for more dense, for example, phlizelin or vinyl, then they are best cut off with a sharp knife causing the rest of the canvas, making the perfect vertical line.
We offer to watch video instructions on how to glue wallpaper correctly: