In pursuit with beautiful repairs in his home, a huge number of people try to apply non-standard solutions that will be able to add the interior and show the special status of the owners of the house. Many have begun special attention to paying the heating system, or rather, they refuse their usual radiators and establish intraole convectors. However, inland convectors are complete nonsense, and why, we will tell in this article more detailed.
Intrapol convectors - why they should not be used in apartments
Why people choose in-country convectors
The main reason why many people choose in-country convectors is a beautiful appearance. In fact, the inner convectors look quite unusually in the interior. In addition to this, you can install French windows. But, on this, their advantages end and we strongly do not recommend using them, especially if you live in the apartment.What is important to know and what disadvantages of intraole convectors
Incompatibility with central heating
And it does not matter what scheme is thought out: two-pipe or one-tube. This is obtained due to the fact that the pipes to the convector are connected via a complex route. And physics to deceive does not work and warm water is trying to find for itself the easiest way. The result from such a connection is one - all hot water goes to the neighbors.Of course, on a single-tube scheme, you can put bypass and water will pass through the convector. But, the result of such an connection one - you will have warm, the neighbors are cold. As a rule, after a few weeks, the neighbors begin to call inspections and write complaints. The result is one: make it forces to fix faults and will write a fine.
Article on the topic: common problems with home heating: reasons and elimination
And most importantly: according to the law, the in-depth convectors can be compared with a warm floor, and it is strictly prohibited.
What convectors can warm
Now there is an option to connect inlets convectors, for this you need:
- Modern plastic pipes and competent calculation;
- Devices depth 120 mm and built-in fan.
But, this option is also not suitable for many people, because the cost of the in-head heater is 120 mm is 80,000 rubles. Many, isn't it? While the high-quality radiators section will cost approximately 5 thousand.
Standings of central heating in any case remain
It is also an important point, because by installing such a device, it is not for the risers. Of course, there are two options:- You can build a special box.
- Hide the pipes with crackle.
But, all this costs no small money and there will be a loss of the area of the room, which is extremely uncomfortable.
Selector heating system
It can be found in new buildings, so many builders are cheating that they can warmly warm the room. We do not argue, it is possible, but you need to perform several actions:
- To buy a heater with a thickness of 120 mm with a built-in fan;
- It will also be necessary to make a screed 12 cm. Do you imagine how much material is it? For example, to add only 7 centimeters, you need to buy 3 cement bags per square meter. We make a simple calculation: the apartment is 60 square meters - it is 180 cement bags. 180 bags are nine tons, such a weight will be able to translate three gazelles. That is, in order to establish in-board heaters, you must order three gazelles, order a rise. Is it worth such money?
Imagine how much cement is needed for pouring a screed
Basic Disadvantages
Several major disadvantages of such heaters, which are worth clear, before purchasing:
- They use electrical elements. For example, the fan helps to improve the air convention, and if it wuresward, there will be serious problems and will have to change it. And here we will note that the fans for such heaters are selling separately. Therefore, in many cases there will have to buy a new heater, it will not be replaced with a certain element.
- Now there is a big range. But, it can actually heat the room only 120 mm heaters with a built-in fan. The rest will not give the necessary heat indoors.
- You can not use such a convector if parquet lies on the floor. This is due to the fact that the parquet after heating begins to expand, respectively, the protective grille of the heater will be protected and repairing or checking the state will not work.
Paws of animals can fall into the lattice, they are also considered traumatic
- Outdoor convector is a real magnet for dust, hair, dirt. Plus, it is extremely difficult to care for it, as it is necessary to constantly remove the grille and try to get to distant seats.
- If the heater begins to flow - very serious problems will appear, as you have to get the whole design and twisted weak points. Ordinary radiators easily twisted and even fragile girl can cope with such a task.
- In the event of a flood, the neighbors will recognize this in initially about it, but only then the hosts. And here it is worth understanding that then it will be at all neighbors at once, therefore it is worth being very neat with its use.
- The windows will constantly sweat, since an effective convention is not created. And you need to kill cold air in the lowest place - on the window. Even a small remoteness of the window from the heat source will lead to fogging and this moment is clearly understood.
Article on the topic: Homemade mudguards do it yourself
Conclusion
Our conclusion: Intrafic heaters are complete nonsense. And if you have the opportunity to establish ordinary radiators, use them.
The only situation when they can be used are in private houses or retail premises. But it is extremely important to choose high-quality devices that will serve for a long time. And also before buying, you need to understand that outdoor convectors are expensive and will have to overpay not only for them, but also materials that have been used.
Preparation for the installation of an outdoor heater
Video on the topic
A good example, why not use outdoor convectors: