Malfunctions of the work of sanitary devices arise in residents of residents often. Causes are varied. Here is marriage products, and poor-quality installation of water instruments and, of course, temporary wear of parts. Cranes and pipes will be tucked both in the bathroom, and in the kitchen. And this means one thing - it's time to repair. You can entrust this work to the master, but if the work is not complicated, then it will not be done on your own.
Find the cause
Yesterday everything was fine, and today is buzzing a crane of hot water? It's time to start repairing work.
The work is not complicated and you can make it and homemade craftsman. Hurry with this work is not needed. First you need to make sure - what is buzzing: with cold water or hot? Everyone turns on each and it turns out, in what position the hum begins.
It is necessary to find out the buzzing pipes with hot or cold water
Installed from which device a buzz appears, it is time to get acquainted with the type of crane-intensity on the mixer. It is she who is responsible for overlapping water.
It happens two types:
- With rubber gasket.
- Ceramic.
Determine for novice plumbing type of shut-off valves simply. If water stops running when twisting on the floor-turn - crane-tan with rubber gasket.
Prepare tools
Found a defective device?It's time to prepare the tools:
- screwdriver with replaceable tips;
- a knife with a sharp blade;
- key - hexagon;
- adjustable key;
- FUM - Ribbon.
Repair of locking devices with rubber gasket
All work consists of several stages..
- Place the water supply to the apartment.
- From the mixer tweaked the crane-shot.
To fully repair it is advisable to completely unscrew.
Article on the topic: Equipment for the manufacture of shutters in production
Device crane
To do this, the crane should be disassembled.
- Remove the protective cap with a lamb.
- Screw the locking bolt with a screwdriver.
- Droke keys unscrew the crane.
Rate the state of the gasket.
If the rubber is still soft, then the edges at an angle of 45 ° are covered by scissors. If the gasket "blew" change to a new one. The edges of the new gasket are also desirable to cut under the same angle.
Reverse assembly is almost the same. A fum-tape (or package) is wound on the crane threaded connection and the part is twisted into place.
Water supply on water pipes and the crane operation is checked. If water flows normally and noise no more means, it means that the work has been successful.
Repair of locking devices with ceramic elements.
Another type of crane-ink - instead of rubber gasket, a locking mechanism from metal ceramics is used. They break very rarely, since the principle of locating water is based on the perfect grinding of locking surfaces inside. But if the crane is bitted anyway - what to do?
In such devices, the silicone gasket between ceramic washers.
Valve gasket separation
Upon normal condition, it must press the rings from metal ceramics, with an open crane.
Repair is almost the same as with products with rubber seals:
- Water supply overlaps.
- Twisted crane-shot.
- If there is a similar spare part at hand - it will remain to replace it and collect the mixer. If it was not, then with the broken part it is necessary to go to the nearest plumbing store. Sellers - consultants will help you choose the desired detail.
- Purchased item remains at home to install in place.
- Check the work of the crane.
We considered in detail the reason why the bathroom bursts the crane when the water is turned on and how to eliminate it.
By the way, experienced plumbing masters are advised to replace the crane with rubber seals to ceramic.
Article on the topic: Frame mounting technology for plasterboard designs
Such elements are more convenient in operation because:
- When closing / opening, you do not need to make great efforts;
- workforce is completely small;
- They are quite reliable and durable.
So that such a mixer has worked for a long time, the installation of a water filter is recommended. Small particles that can damage the metal ceramics will linger in the filter.
The reason for anxiety There may be a situation when the mixer is not buzzing, but when opening the water, a strong noise or "howl" is distributed. Often the reason lies in the cartridge.
To understand this, you must alternately check the hoses from the pipes to the mixer.
Opening alternately cold and hot water, the noise source is found.
You can try the water supply hose hold your hand. The source of noise can be the vibration of the hose under the pressure of water. Securing the hose in a stationary position, you can get rid of the source of the buzz.
If noise does not disappear - the reason in the cartridge itself. Repair or complete replacement will be required.
Why noise toilet tank with water set
The source of increased noise in the apartment can be the drainage tank of the toilet. According to the experience of repair masters, this problem is easily solved on their own and quickly eliminates.
Most often, the cause of excessive noise is an intake mechanism.
Tank toilet can make noise on a par with pipes
As a rule, when assembling drain reinforcement, a tube is installed on the intake valve, which one end drops almost to the bottom of the tank. When the water in the tank begins to fill and closes the tube - the noise disappears.
The reasons are now not important - or the tube flew herself, or simply forgot to put it when assembling. The main thing is to eliminate the noise of water when the tank is filling.
If the tube flew - it is simply necessary to put it in place.
If the tube is lost, you need to choose a suitable segment of a plastic or rubber tube and fasten it in a drain tank. Learn more about how to fix the drain tank toilet bowl.
Article on the topic: Provence in the interior with your own hands
Why when you open a crane buzz pipe
Many residents of high-rise buildings are familiar to the unpleasant roe from water pipes.
Why did this unpleasant sound effect appear and how to deal with him?
Several options:
- The house was overhauled Water supply systems, as a result of which the pipes are connected or mounted "on an ambulance hand." The management company must eliminate all the shortcomings. Pipes that "hang out" must be consolidated. And those sites where the pipes pass close from each other, or remount or make isolation of each pipe using the mounting foam. Aesthetically and beautiful this repair will not look like, but the noise will stop.
- Pipes vibrate from excessively large pressure In a plumbing network. Manifests itself when closing locking devices. If noise with closed cranes intensified, it means that complex repairs are required on the highway of the water supply. It is impossible to cope with residents at home with this problem. Controlling the management organization should be engaged in troubleshooting.
- Very old pipes can also give the same effect. . It is manifested in the houses of the old building, in which a long time was not overhaul to replace the water supply. The inner diameter of pipes is reduced under the influence of rust increments on the walls and sediments of salts, with the previous pressure of the water in the system. This causes a buzz and rattling. It will help to replace faulty metal pipes on metal-plastic. So you can eliminate the problem of excessive noise of the plumbing system.
- Faulty locking elements or plumbing in a concrete apartment . The buzz from water pipes can be transmitted from damaged cranes and mixers. If the replacement of spare parts in a particular apartment did not help to eliminate the noise, it is necessary to look for a source of rattling in each apartment, covering the main shut-off valve alternately in each of the tenants.