How to add paper for snowflakes and what is it necessary for? This should be known in order for snowflakes to get a beautiful and correct form. From how the paper is folded, the success of all work depends. There are several ways to make the paper to cut the snowflakes correctly. In this article, each of them will be disassembled, ranging from simple and ending with the most difficult.
Disassemble options
The first option is the most simple. To begin with paper, you need to roll five times. Four times in pressure, and the last fifth time diagonally. The ornament will be beautiful, but angular.
Very important! So that the snowflake is even at the end of work, immediately cut off all the extra parts.
After the easy way is mastered, you can move to more beautiful and complex variants.
Second option. Below is a diagram in which a visual example of the correct folding of paper sheets for a pentagonal product is shown.
Third option. A little harder to fold the hexagonal snowflake.
- Take a square sheet of paper and collapse diagonally. Then minimize in half. Place the last bend. Now you should take a circuit and draw a circle. The maximum radius that will fit on the workpiece.
- Leaving the radius for the same, put a circulation needle with the edge of the circle where the bending of the leaflet and make a notch. Similarly, to make both sides of the triangle.
- Bend the edge so that it was the same as a serif on the left.
- Turn over the product and bend the edge of the right side
Collapse in half, if extra tails interfere with, cut off, and if not, draw a beautiful ornament on them. There is another option to fold the paper for the six-pointed empty. Take paper and minimize diagonally, then cropping extra paper. Should go square. The second time to collapse according to the diagonal. A triangle will come out to be released on three halves, roll one half, crop ends, minimize the second half. On the picture everything is clearly visible.
Article on the topic: Sleevecavka for a boy with knitting needles: how to tie a jig for kids up to a year, 1 year and 7 years old with a photo
Semigram Crystalik
Before you start cutting a sevenflated snowflake, it is important to understand how it is necessary to correct the sheets of paper for the seven-angled guns.
To make a sevenflated snowflake, a square sheet of paper is needed again and split the workpiece into seven cells. It is most convenient to do this with the help of the transport. For each sector, it is necessary to make an angle of 25, 7 degrees.
The right corner of the leaf bend so that 3 left cells are open. Similarly, to adjust the right side, the degrees of the angle are preserved. It is necessary to take the right side of the leaf and cover another cell. Next, it is necessary to minister the starting material for the snowflake so that the left side of the triangle is at the bottom, and the right side is at the top. Paper for snowflakes is ready, the product should turn out to be smooth, symmetrical and beautiful.
It is convenient to fold the leaves of paper for snowflakes for these drawings:
Mastering the process of folding paper sheets for snowflake is easy, but then all the scenery will turn out exactly, quickly and right, without flaws.
Video on the topic
Video about how quickly and correctly turn the paper for snowflakes.