Many needlewomen were sure to think about whether it was possible to sew lingerways. Sure you may! We want to offer you a master class who will tell how to sew thongs, one of the numerous types of panties.
For such panties, old knitted things (T-shirts, dresses, etc.) are perfectly suitable.
The only recommendation - the knitwear should be desirable to have Liker, although it is not necessary. In addition, it should be prepared elastic bay for edging, as well as two pieces of plastic or metal rings.
First of all, you should decide on the technology on which panties will be cut down. After all, there are many options for such a model, they can be high or low, have lace or not, etc.
In this case, we will sew such mini panties, for which the corresponding pattern should be performed.
As a rule, there are many variants of such panties that can be modified directly on the pattern. Pay attention to that site, thanks to which the panties and got such a name. The most narrow place in the already finished panties should be a width of no more than one and a half centimeters. Otherwise, the briefs will not be a comfortable thing for everyday wearing. As a rule, the width of this site is equalized by the width of the used edging.
We cut the product from the fabric, while only one item will need. If you have a drawing, pick it up at this stage.
Separately cuts "Lasting" for which you can use all the same option.
However, note that if the main material is not natural, then it is better to choose something for the "lastician".
Using overlocks process the upper edge of "lastics", after which it can be noted to the main part. You can use a claw, with which the parts simply glued.
For edging products with rubber band, you should start from the rear top edge.
Article on the topic: Spring Flowers from corrugated paper
Gradually goes to the sides of the panties.
Here you should be attentive, since it is necessary to leave free gum for about 20-25 cm on each side. The size of such residues depends on your own sizes and the ability of the used gum range. Better leave pieces more, after which their length can be adjusted.
At the end, the top of the front of the panties should be treated, wherever each side should be left three centimeters of gum.
You can drive the rings to the left side areas, then unscrew the allowance to the offstairs side and fasten the rings with a line.
Now panties can be performed, only pre-left tails should be touched into rings and stick the free tail pin, thereby adjusting the size.
All rubber bands should be fixed using Zigzag seam.
After the extra pieces of gum will be cut off, our product is ready to operate.
During work, we advise you to pay attention that the rubber band during its sewing should not be stretched, and if it is a little stretched, then a rather decorative wave edge may turn out.
After sewing, all the seams should be sacrificed to silently so that everything fell into place.
If you work for the first time with a rubber band, we advise you to practice on pieces before you begin to the main product.