Soundproofing Door and its seal is very important
The moment to pay attention to when installing the door. Firstly
Soundproofing Door is the absence of drafts, that is, a favorable reflection
on human health. Secondly sound insulation of the door, it is measured by filtering and
The absorption of sound, that is, you can say the direct "duty" door. Like himself
make a seal for good sound insulation doors, shown on this
Site page.
There are various types of masters,
allowing to prevent the appearance of drafts, but the greatest value
It has a good fit of the door itself. For example, if you give a rack to
the door is hired, then the latter will stop closing or
open.
In most cases, it is enough to inspect
Door to determine the place of jamming. If it fails to do, then
Close the door and enter a piece of thin cardboard in the slot between the door and
Door frame (box); Moving cardboard along the slot, easy to install
The places of the tight dock leading to the jail. This task can be solved
In other way, applies to the edge of the door with a color chalk.
Closely close and open the door and then carefully
Inspect the line: in places of tight docking doors and boxes will be
erased.
Another reason for the door of the doors - its saving due to
Weakening door loops. The easiest way to tightly spin screws; if this
does not help, then remove old screws, score in the holes from them
Wooden plugs and tighten new ones. Door can love when swelling
One of her sites. In this case, it is recommended to put under one of
loops fine gasket or cut off part of wood with a planer. If it is hired
edge door with latch, then it is best to remove the door and process the edge with
hinges of the plane; It is much easier than leave the door in place, take off
Castle, and then to trim the stirring edge. Deciding all the indicated problems,
Select the default rail of those that are presented in the figure. For
Sliding doors use the same techniques that were used when sealing
sliding windows.
Types of lack of plates. Great strength I.
the wedge-shaped plank is different; Plastic tube is good
its elastic properties that allow reliably to close the slots between
Door and frame. Very available at the price of tapes from foams with adhesive
layer; They are two species - rectangular and pointed. Enough
Effective metal and plastic rails with brushes.
Article on the topic: Balcony decoration Sandwich panels
Rectangular tape from foam;
Pointed ribbon of foam; plastic tube; Wedge-shaped
Planck; Planck with a brush
Door adjustment. If a
Hences the upper or lower edge of the door, then process them with a branch or
skirt. When sideways, the lock is installed, you can
Solve the problem with a laying of wood or plastic. SUPPLY
a piece of wood under the door, unscrew the base of the loop and down under it
gasket; After that, fasten the loop. Follow the rule:
If the top of the door is hired, the gasket is placed under the base
Bottom loop and vice versa. If the edge of the door with loops is stuck, then
Install the gasket in that loop that is located closer to the place
jealous.
Installing a wedge-shaped plank. Cut
Planks in size so that they can be installed at the top
Door opening and sides. Tops of vertical slats and both ends
The top plank cut at an angle of 45 °. Do not forget to cut opening for
Loops and door lock. After that, the planks are shown on
Figure below.
Installing outdoor planks. Cut
top and side slats for the required size and install them in the door
The opening, as shown in the figure. Loosely screwing the plank screws,
Check how closely the door is adjacent: ideally between the door and
Planks should pass a sheet of paper. After that tightly tighten everything
Screws.
Sealing lower part
Doors
External doors should always be seal, while
Fastener rails are nailed to the inner facial surface of the door. If a
It is required to maintain a higher temperature in one of the living rooms,
It should also be sealing from an external or inner side.
Network rails are very diverse, among them you will always find a suitable
To your doors. Flat threshold rails (downstairs, on the left) consist of
aluminum or plastic base on which brushes are attached or
Rubber plates. Such rails will suit both internal and for
external doors. Reiki with brushes It is recommended to use for seal
sliding doors, since other types of regions will prevent
slide. Some brushes have a plastic shield that prevents
Moisture penetration: It is clear that such railings are used to seal
external doors. Combined rails (below, in the center) consist of two
parts of a nylon brush and a metal strip. In this case, the brush is attached to
Doors, and a planka - on the threshold. External doors are equipped with special
Reiki, the form of which does not allow water to penetrate the house (downstairs to the right).
The groove carved in a similar rail does not give water to penetrate the bottom.
Article on the topic: Kitchen basket for spices do it yourself (drawings, schemes, photos, master class)
Installation of flat threshold
Reiki
How to fix the rail. Cut the rail to
Door width and screw it to the bottom of the door with screws. Rake must
to be as close as possible to the floor or threshold, but not to prevent the movement
Doors. Many rails have oblong holes for screws that
Allows you to easily adjust.
Installation combined
Reiki
How to fix the metal bar.
Cut the bar and brush along the length of the threshold. Screw the bar with screws like
shown in the figure; Make sure that the scoring edge of the planks was
facing the doorway inside.
How to install a brush. Install the brush
So that it creates a light pressure on the bar. Using screws,
Screw the brush at the bottom of the inner facial surface of the door.
Installing the racks on the external
Doors
How to fix the rail. Cutting a ray
Suitable length, place it so that the door freely opened and
Closed. The lower part of the rail must be lured (or above a couple
millimeters) with the lower edge of the door. Closing the door, strengthen the rail with the external
Sides with screws or nails. Use screws or nails, not
Rust. Gap between the rail and the door surface make
Filler, it will prevent the decoration of the tree.
