How to stroke a jacket of wool, flax, venels, synthetics

Classic costume makes a fit fit and elegant. It is believed that the properly stitched and well-fired jacket out of good fabric in the iron does not need. However, the use of a variety of tissues, as well as various circumstances, often lead to the fact that the question "how to stroke the jacket" becomes relevant. This operation is not difficult, it can be performed at home - if you know the correct sequence of actions and some small secrets.

Is it possible to do without an iron?

Before ironing any dense product, you need to try to remove the chances without an iron. The best way for this is the use of an excavator. With its absence, the jacket should be carefully hanging on the shoulders (lapels and challenges of pockets it is desirable to fix it with pins), place it in the bathroom and open hot water (with the door closed). Such steam processing should be carried out within 15 minutes or half an hour, after which the steamed thing should dry well . This method is the best and in order to put the leather jacket. If strong chances were formed on it, after sipping, this place should be strained on a flat surface and press the press.

Sequence of ironing

The standing of a suit with its tailoring is a mandatory and quite complicated operation. To perform it yourself, you need a ironing board, preferably with a special mini sleeveless board. With its absence, any smooth surface with a soft bedding is suitable, as well as a terry towel and, if possible, the rolling pin. The real-wool product is better to iron through a wet napkin, while you should prepare a water container in advance. Materials of another type can be ironed with an iron with a steamer.

Before ironing, check and clean your pockets. It is best to perform ironing after washing, as a last resort, you need to remove all stains from the fabric and how to brush it . After that, the product is turned inside out and install the heat mode in accordance with the labels on it. The stages of how to correctly stroke the jacket, have such a sequence:

1. Carefully stroke the wrong pockets.
2. The sleeves are put on a mini-board, a rolling pin or roller from a towel and, turning, ironing so that the arrows are not formed.
3. The roller from the towel is placed under the shoulder seams and carefully wearing them.
4. They smooth lining on the shelves and the back.
5. Change the thermal mode of the iron (if necessary), ironing the weld and turn the jacket is obvious.
6. The sleeves are again put on the roller or mini-board and, slightly touching the iron, silent the flooded places.
7. Especially neatly smoothed collar and lapels.
8. Then go to the shelves and the back, carefully processing the sutures of the souls and relief.

Article on the topic: Japanese magazine "Understanding knitting crochet"

An ironed jacket should be made to shift at least half an hour.

Small secrets

So that the thing after the iron looked "like a new one," you need to consider from what fabric it is sewn.

• Woolen products better disappear through the wet napkin, almost without touching it with an iron.
• Fashionable flax jacket without lining is ironed with a saparwoman from two sides.
• A jacket with a pile, especially velvene, stroke with a steamer or through a wet napkin, spending iron in the direction of the pile. If the velvet or velor material contains synthetic fibers, it is better to iron it at a minimum temperature.
• Synthetic products are practically not impaired, but they can be swallowed with an inside with a warm iron.

Perform these simple recommendations - and your favorite jacket will last an elegant look.