Simple on its design canopy from the sun for the beach will appreciate many holidaymakers. In contrast to the umbrella, it creates a lot of shadows; It is less than the umbrella, since it is made of sweater materials; The design itself is light and collapsible, so that it will easily fit into a marching backpack. How to make such a canopy with your own hands, see and read in step-by-step instructions.
Materials
For the manufacture of a canopy from the Sun do it yourself prepare:
- manual drill;
- rubber hammer;
- inch PVC pipe (4 pcs. 9 90 cm and 4 pcs. 60 cm);
- inch PVC adapter - 8 pcs.;
- inch PVC clutches - 4 pcs.;
- Plugs - 8 pcs.;
- bolts 0.5 inches and hex nuts to them - 4 pcs.;
- washers (2 pcs per bolt);
- Parakord;
- tarpaulin;
- Tent pegs.
Step 1 . Create four plugs. Drill in each of them a bolt hole. Insert the bolt, washers and nut along the scheme shown in the photo. Thoroughly tighten the bolt.
Step 2. . Snap the resulting plugs into two long PVC tubes and two tubes shorter. So that they sat down thoroughly score them with a rubber hammer.
Step 3. . At the ends of the same pipes, on the other hand, suck and PVC adapters. Also also for strength to pass the rubberized hammer.
Step 4. . For one of the ends of the remaining four pipes, use the plugs without bolts. On the second - adapters.
Step 5. . So you will have reference structures for the awning. With the help of the coupling, these parts are converted into two high sticks for the front of the canopy and two small - for the rear. At the top of the assembled parts you need to drill holes. Through them, you will skip Parakord when building construction on the beach.
Article on the topic: Crochet: Schemes and models
Step 6. . To assemble the canopy you need to spread the tarpaulin or prepared fabric at the installation site.
Step 7. . Through the corners of the tarpaulin, skip Parakord, pulling it on the sides.
Step 8. . Tie the ends of the rope to the stakes and take them at an angle to the tarpaulin coating.
Step 9. . In one of the corners of the front of the canopy, install a long tube, the painter is short. Adjust the tension of the tarpaulin with the help of a rope by skipping it through the holes in the top of the pipes and through the bolt.
Step 10. . Install two more pipes and adjust the Parakord again. Bolts should pass through cutouts in a tarpaulin, increasing its tension. Secure the resulting attachment by another nut so that the tarpaulin coating does not fly when the wind gusts.
Canopy ready!
