Wiring isolation is an important process that needs to be performed. Otherwise, you risk getting a closure in your home and then all your property and health care will be in danger. An error actually allow is very simple and they can lead to terrible consequences. In this article, I decided to tell you several basic ways that every person can apply without extra effort.
Wiring insulation: Precautions
Before you decide to have insulation of electrical wires, you must clearly understand that they must be disconnected from the network. It is best to turn off the voltage using the circuit breaker. Next, you must make sure that the voltage is not completely.Pay your attention to the materials you are going to use, it is very important. If he can challenge - this will lead to an accident. Read Next My Overview of Materials for Isolation. Immediately note, it is impossible to isolate the wire under the ground.
Wire insulation tools
To date, the following materials can be distinguished for insulation of wires and cables:
- PVC tape. It has good stability if the room is wet, it does not destroy and does not fall apart with time. But it is better to apply it only in dry rooms, it will guarantee you a long service life of isolation.
- HB of tape. It is considered excellent material, even better than the first option. It is more resistant to moisture and other loads. Use it even to connect wires in the car, which is already saying for its quality.
- Shrink tube (here). The optimal option, we recommend it everywhere, because it perfectly keeps insulation under water, in the ground and even in the car. Install simply, she also has a long service life. This is the best material at the moment.
- Caps Peep. They are used extremely rare, only in those cases when it is necessary to insulate the twist. The properties resemble a heat shrink tube.
Article on the topic: Washing machine with water tank
Wiring insulation: basic ways
And so how to insulate the wire. Now we approached the main stage in our article. So, as I gathered a few materials for you for you, how to apply them to you and tell you.Wiring insulation isolant
Initially, you must twist all the wires with each other, about where to do it in the article: the connection of the wires. If you have a wire with a lot of live, it is better to solder them with each other.
Initially, we take the isolate and begin to unwind it, then we begin to slowly wrap the entire wire, as shown in the photo below.
Remember that you should have two layers, in no case cannot be allowed that the part of the wire remains not exhausted, because it can lead to a closure. Interesting features at the ABS cable.
Wiring insulation by heat shrink
Wire isolation in this way is one pleasure. But remember, the tube needs to be dressed until you connect all the wires with each other. Insulation of copper wires in this case does not take much time.We proceed to the very insulation process. When you have done the actions above, we put on the cap.
Next, we must heat it. It is optimal to use the construction hairdryer, if you do not have it at hand, try carefully to warm this place in a lighter. However, see that the thermal layout is pulled out completely on the wire, because the insulation resistance of the wire does not forgive errors.
This method is better to apply for cases when you are going to use a cable in water, in the ground and in other wet rooms.
So we disassemble all the ways of wire insulation. We hope this information was useful for you, ask questions. If you did not find the answer in this article tell us, we will definitely make it for you.
Article on the topic: Foundation for the fence: how not to bury extra money
Wiring insulation: video
Articles on the topic: how to make a branch of the wire.