Wall pastries with wallpaper - the most popular and simple type of wall decoration. The technique of performing this type of finish cannot be called intricate. Therefore, to perform in the apartment. Wall around the walls with their own hands may well and unprofessional. However, high-quality stacking of walls requires compliance with some rules and nuances in the process.
Wallpaper shook scheme on the wall.
Wallpaper selection and preparation of the necessary tools
In the modern construction market, wallpaper for walls of any type is presented in such a rich assortment that it is difficult to stop your choice on something one. Therefore, to begin with, it is necessary to determine the priorities and the choice of the most suitable material for finishing your home.
The kitchen and the corridor is better to dry the most durable and resistant to wear by wallpaper. A dense moisture resistant vinyl is suitable here, the so-called washable wallpaper, suitable for wiping with a wet sponge or cloth.
Tools for shook wallpaper.
The bedroom can be decorated with any type of wallpaper in accordance with the room design. Children's better causing inexpensive, environmentally friendly, paper wallpaper, and here you can experiment with the combination of different colors. Dear textile wallpapers or silk-screen printing are suitable in the living room.
Wall pasting with wallpaper requires the preparation of girlfriend materials and tools, they should also be purchased in advance. Here is the list:
- wallpaper glue and container for its dilution;
- Putty and non-trap;
- sandpaper and holder for it;
- Large line and plumb;
- knife or scissors for trimming edges;
- a wallpaper brush or rubber roller;
- Sponge or rag for wiping.
When everything is ready for repair, you can proceed directly to the process. Consider the sequence of stages of walls of the walls with their own hands.
Alignment and markup of walls
Preparation of walls to shook wallpaper.
First of all, it is necessary to clean the walls from old wallpaper, if any. To do this, you should wet them with a wet sponge or roller and with the spatula to scrape from the wall. Then, using an acrylic putty and a spatula, it is necessary to thoroughly align all the recesses and potholes on the walls, pre-removing nails sticking out of the wall, screws, hooks.
Article on the topic: Where to fall asleep powder in a washing machine?
The spacion layer after drying should be seized, applying sandpaper fixed in a special holder. Then impose a layer of primer. This will strengthen the strength of the putty and increase the degree of gluing the wallpaper canvas to the wall.
Now you can go to the wall markup. To do this, in the corner located next to the window, we list with a pencil using a plumb or a level of a strictly vertical line, it will help exactly stick the first wallpaper band. Then we are determined with the upper and lower edge, measure the distance between them, add 5-7 centimeters to this number 5-7. This will be the length of the wallpaper canvas. The preparation and marking of the walls is completed, you can go to the next step.
Cutting wallpaper and glue preparation
The usual roll length is a little more than 10 meters. If the wallpaper pattern does not require fittings, 4 canvases will be obtained from one roll, and taking into account the fitting the pattern will be released only 3 canvases. The remaining large pieces are commonly used when covered with walls above window and doorways.
Table of calculating the number of wallpaper.
We proceed to cutting. We decline on the floor with a picture upwards upwards, measure the desired length (not forgetting about the spare 5-7 cm), we make notches on the edges, bend the canvas on these notches and knife pass through the fold line. The first canvas is ready. Roll over the other roll next to it, customize the drawing, usually the displacement of the pattern is from 15 to 50 cm. Cut the second cloth in the size of the first. In the same way, measure and cut the next 5-6 canvases.
After cutting wallpapers, we will prepare glue. The modern market offers a wide variety of adhesives: painted, colorless, for heavy vinyl and thin wallpaper. After selecting the appropriate glue, we break it according to the instructions. This is usually not a very complex process.
In the container with warm water, smeared with a thin flowing of adhesive powder, constantly stirring it and not allowing to form lumps. Then we give glue to swell, withstand it for a few minutes and rebel to vigorously. Now the glue is ready to apply on the wallpaper. Go to the next stage.
Article on the topic: Gifts for March 8 do it yourself
Application of glue and the beginning of the salary
First of all, the finished glue is applied with a roller or brush to the surface of the wall as an additional primer. Then the prepared canvas turn over the face down and begin evenly and densely along the entire length of the glue, thoroughly missing the corners and edges. It is very convenient to use color glue, when it is applied, it is clearly visible, where there are no missing areas, and after drying it is discolored.
The correct order of the wake of the room with wallpaper.
When the canvas is completely covered with glue, we fold it with a "harmonic" adhesive side inside, without pressing the collar. Withstand wallpapers for the time specified on the package with glue, it is usually 5-7 minutes. In this case, the instructions should be accurately accurately, since the dense inspires can be turned off, and thinly disturbed swelling and spread.
When the glue was absorbed, we take the cloth for the top edge, climb a ladder or a chair, we apply it under the very ceiling, carefully deploy, at the same time directing the edge of the canvas accurately along the planned vertical line. After making sure that the edge of the wallpaper coincided with the control line for all length, you can smooth cloth using a special wobbly brush or rubber roller.
We can carefully straighten, starting from the top and gradually running the brush down and to the sides, trying to drive out the outside of the air and smoothing the folding folds. The glue that fell on the front side of the canvas, we remove the rag or a sponge, so that after drying there is no spots. Immediately after sticking the first strip, we cut off the surplus of the wallpaper from above along the planned line and below the plinth line.
Similarly, we glue the second and subsequent lanes of the wallpaper for finishing the previous one, trying to feel good to fit the edges of the canvases, without leaving gaps and cracks and not forgetting about the careful combination of the wallpaper pattern. When one wall is saved, all edges of the canvases should be thoroughly wedged with a thin brush, since they are most often dug.
Article on the topic: Making Woods and Longs with your own hands
Corners, door and window openings
The most difficult moment in the design of the walls with their own hands is the bolding of the corners.
But if the first canvas and all subsequent passed smoothly, then it is not even difficult to salary correctly.
So, you take the indoor corner of the room. To do this, it is necessary to measure the distance from the edge of the last glued canvas to the angle in the upper, middle and lower part. Then to add 1 cm to the largest of these distances and cut the wallpaper band with such a width. Thus, after sticking to the wall, this strip swept a little angle.
Wallpaper sticking circuit in corners.
Next, it is necessary to draw a strictly vertical line on the next not plane wall, retreating from the corner of the segment equal to the width of the second strip left after cutting the first. After marking, stick the second strip clearly on this line and smooth the wallpaper brush. You can use the same scheme for saving external angles.
Carrying door openings in the following order:
- We glue the wallpaper canvas so that it is overwhelmed by the door jamb.
- Slightly printed under the paper the angle of the opening and make an incision at an angle of 45 ° in this place.
- We press the cloth with scissors to deepen the door jammer to schedule a cut slicer.
- Gently and smoothly cut off the extra stripes on the intended line.
- We put the space above the door from the ceiling to the top edge of the jamb.
- The second cant is saved similarly to the first.
Window openings are accumulating along the same scheme as the door, sticking the blast wallpaper on the angle of the opening and cutting the extra pieces along the fold line.
After completion of the walls, it is necessary to close the windows and doors to the room for 1-2 days so that the walls are well dried. Using this technology, you can also save the walls of your apartment without high costs.