Photo
It should be known that there is no higher quality and convenient material for the walls of the walls than the phlizelin wallpaper.
If it is planned to design a ceiling and walls, it is originally necessary to stick them, and then begin to stick to the wallpaper.
How to glue phlizelin wallpaper: technology
The material of this type has the following advantages:
- The width of the roll is approximately 1 m, as a result of which the indoors will be much less junctions than in the case of using ordinary wallpaper.
- Increased material wear-resistant material and abrasion resistance.
- You can hide small cracks and other defects on the basis of the wall.
- If you want to change the walls of the walls, the old material can be easily removed from the wall in dry form, that is, you will not need to spend time to bite the wallpaper.
- High light resistance.
- You can hold the wall from the roll. In this case, the work area will be reduced to a minimum.
- You can produce wet cleaning with reservoirs.
- The material is able to skip steam and air, while it will not change its texture and sizes, which cannot be said about ordinary wallpaper.
- Minimum debris and dirt. This is due to the fact that the glue will be needed exclusively on the wall.
- It can be painted many times, which allows you to change the interior design.
- The material is made of environmentally friendly raw materials.
- Wallpaper comply with all sanitation standards.
- The material can be glued both on the walls and the ceiling.
Wall cleaning scheme from old finish: a) Cleaning, b) smoothing, c) Move tool.
Before glueing meter fliesline wallpaper, you need to measure the height of the walls. If the junction of the wall and the ceiling will be decorated, then it should be pasted with wallpaper before pasting walls.
The height will need to measure from the floor to the ceiling or cartel if the latter is used. To the magnitude that will be obtained, you will need to add 10 cm for stock.
On the wall with which wallpaper sticking will begin, at a distance of 1 m from the corner it will be necessary to repel a strictly vertical line, for which you need to use a plumb and a long ruler.
A plunder can be made with your own hands from the cord of the desired length, while one of its ends it is necessary to tie a heavy bolt or nut.
Article on the topic: Battery decor do it yourself
The elements that will be needed to glue the fliseline-based material:
- The material of the wall decoration itself.
- Construction sharp knife.
- Putty knife.
- Primer.
- Putty.
- Special glue.
- Reference or long line.
- Rag.
- Meter.
- Roller or wallpaper brush.
Fulfillment of all preparatory work
Wall decoration scheme before cutting wallpaper.
Before sticking wallpaper, you will need to prepare the wall. It is necessary to make sure that the wall is fully even, there are no tubercles on it, cracks or some other notable defects. The base will be needed to carefully clean from the old coating.
So that you can easily remove old wallpaper, you need to wet the coating. This can be done using water and rag. The moistened material can be removed from the wall with a spatula.
If the wall is not perfectly smooth and needed to perform repairs, before glueing the material on a flieslinic basis in the corners and other problem places, you will need to perform putty. After that, the wall should be braced with glue or with the help of primer deep penetration. If glue was chosen, it is recommended to make a weaker mixture.
Speaking about how to glue phlizelin wallpaper, you should know that there are 2 basic rules that need to be observed:
- The surface on which it is planned to glue the fiber-based material, should be dry and smooth.
- There should be no drafts and air flows in the room, for example, from air conditioning. All windows in the room you need to close tightly.
Next will need to prepare material for pasting and coloring. For this you need to cut them on strips. It is important to remember that it is necessary to leave the allowances of 10 cm on each of the canvases. It is important to remember about the observance of the drawing, if there is such a need.
How to apply glue on the wallpaper?
The material should be launched from the corner, downward. At the same time, it will be necessary to successively smooth it in the vertical direction using a roller or a brush for wallpaper.
It is necessary to press the new layer to go to the edge of the glued.
The glue will need to smear not on the opposite direction of the material, as they do in the case of conventional wallpaper, but exclusively on the wall.
Scheme of applying glue to wallpapers: 1. The molding of the canvas of the celestone. 2. Folding the canvas in half.
It is important to choose the right glue that is suitable for gluing phliselin wallpaper. With the choice can help any store employee who specializes in the sale of materials for construction and finishing.
It is important to know that the advantage of such a material is that in this case you do not need to withstand some time for impregnation of wallpaper.
Article on the topic: Designer Tips: How to expand the room with one-photo curtains
Such material is able to ensure the stability of the shape and size of sheets. Before applying glue on the wall, it is recommended to familiarize yourself with the information that is specified on the packing of the adhesive mixture and on the wallpaper roll.
The glue should be applied to the wall, which was previously prepared.
How to glue wallpaper on a fliesline basis: sequence of work
After applying the adhesive solution, you need to take the first wallpaper band, to fit it in height, then stick up on the wall on the wall. The second side must be turned on an angle. Do not worry, if it is not possible to get an exact coincidence in the upper part of the wall, because at the end of the wallpaper that will perform, you can cut. First, they need to just turn. Next, you need to start smooth out the material that moves air from under it. To do this, use a wallpaper roller, a spatula or a piece of pure fabric.After performing smoothing, you need to take a metal spatula of a large width and a sharp knife. The spatula is used as a guide for a knife, it is applied into the wall of the wall and the ceiling. After that, the knife must be cut off the surplus of the wallpaper. If it fails to cut raw wallpapers, you need to wait until they dry, then try to trim them again. If the wallpaper in some places were not completely punctured, it may be necessary to make a liner material.
How to glue meter fliesline wallpapers online?
Wallpaper sticking circuit.
Each layer is stuck online with the previous one. In this case, there will be no problems if the wall was leveled at the preparation stage.
In the process of gluing a new layer of jack to the previous one, you will need to customize it in height. A clear joint is not allowed to achieve with the use of material stretching. Even if you first do it, after drying the glue wallpaper will disperse.
If it is impossible to achieve an ideal joint and monotonous wallpapers are used without drawings, you can go for a trick. The canvas should be labeled with the previous one with the previous one, the intersection should be about 2-3 cm. Next, using a sharp construction knife, it is necessary to make through cuts in the place where the canvas intersect. It is important to cut through 2 layers at the same time. In the end, it is necessary to extract trimming, losing the mix with a glue mixture and straighten the layers, getting a smooth joint.
How to glue wallpaper in hard-to-reach places and corners?
Special attention should be paid to the woven walls in hard-to-reach places. In this case, refers to the location of sockets, batteries, switches and ceiling. The edges of the wallpaper must be smeared with the adhesive mixture to ensure the reliability of their fixing to the base of the wall. It is extremely recommended to allow the adhesive solution to the main side of the canvas. If for some reason it happened, you will need to quickly remove glue from wallpaper using a wet cloth. Then the wallpaper should be wiped with a dry base.
Article on the topic: Wall murals for the kitchen: how to choose what sizes there are, drawings, landscapes
Corners of corners with wallpaper.
Glue fliesline wallpaper next to sockets and switches need carefully, and the electricity will need to be disabled. Before this should be measured, what size the band will be needed, after which it is cut.
After the adhesive mixture is dry, in the opening, it is necessary to deepen the necessary sizes. Upon completion of all the work, you will need to fasten all the outlets and other elements.
If it is planned to glue the material of this type on the ceiling, then you should know that the technology does not differ from pasting wallpaper walls. The only difference is that in this case you need to find an assistant who can keep the wallpaper canvas.
In the corners, the canvas need to stick so that the nesting on the adjacent wall is approximately 2-3 cm. If the layer of large sizes is touched during the sticking process, then it is necessary to cut it with a sharp knife to the desired size.
There are 2 options as you can stick the finishing material of this type in the corners of the room:
- The first method is used in the case when you need to stick the material with a pattern. The canvas should be pasted from the angle, while the recess with another layer should be approximately 2-3 cm. The reheat can hide the defect if there is an uneven angle.
- Another way is suitable for monophonic wallpaper. The canvas should be labeled from the angle, after which the knife cuts into 2 canvas, remove the excess and at the end to straighten the joint.
How to paint fliesline wallpaper?
If after placing the room with wallpaper you need to paint the material, then you need to know what water-based paints are best suited, which are resistant to abrasion and cleaning. It is recommended to use latex or acrylic paints that have a silk effect. If you choose these materials, you can emphasize the features of the wallpaper texture.
The first layer of paint is applied approximately 24 hours after the glue dries. To do this, use a roller, which corresponds to the type of paint acquired. Choose it will help an employee of the same store. The second and all other paint layers are applied in a few hours.
It is strictly allowed to add water to the paint.
It is quite simple to glue such wallpaper, it is only important to prepare the basis and follow the sequence of actions.