A pretty pretty multicolored bracelet can be weave in just 20 minutes. The trick is to use the so-called disk for weaving. In fact, this is an ordinary circle of cardboard with several slots in it, but with it bracelets to weave much easier. In the article you will learn how to make a similar disk and use it when weaving the bracelet.
Required materials and tools:
- 7 threads for weaving (knitting) 60 cm each each;
- cardboard sheet;
- scissors.
Cut the circle
Pencil circle the circle around the glass applied to the cardboard. Cut the circle and make 8 small slots (1 cm), evenly arranged around the circle. Do the hole in the center of the circle.
Tie the knot
Fold together all 7 threads and tie at the end of the node so that the end of the received cord looks out of the knot for a couple of centimeters.
Insert the thread
Grind the thread through the central hole in the cardboard. Insert one thread into each slot except the top. That's how your disk should look like.
We start tolerance
Now you can start weave the bracelet. To do this, remember only two actions: 1) Keep the disk so that the empty slot is at the top. Pull the thread from the right bottom slot and insert it into an empty top; 2) Now the right bottom slot is empty. Turn the disc so that it becomes the top. To weave the bracelet, you just need to repeat these two simple steps.
End
When the bracelet reaches the required length to fit on your wrist, remove it from the cardboard disk. Tighten the ordinary node in a place where weave ends. Then make the same node at a distance of about 1.5 cm. Cut extra threads.
Bracelet ready
Bracelet ready! To put it on the hand, thread the end with one node into the gap between the two nodes on the other end of the product.
Article on the topic: Detailed crochet lesson Napkins for beginners