Making a sofa do it yourself
In the design of the proposed version of the production of the sofa there are no complex compounds of parts, because the framework will stick to the plywood, which will need to be attached to the seat and the back throughout the plane.
On the principle of lining, which is used in simple boxes, the frame of two parts of the seating and the back will be assembled.
Connection locations, if desired, can be further reinforced with corners and glue. And most importantly - it is necessary to fasten two screws on each connection.
You need to start with a seating frame, which is the basis. To four supporting legs made of wooden bars of a durable tree, which in the section have a size of 70x80 mm and in a height of 100-150 mm, it is necessary to attach the bar of the crossbar with a cross section of 40x40 mm. To increase the reliability of the design, you can fasten them with metal corners.
Length and width of the sofa can be chosen arbitrarily, to its taste. It is only necessary to remember that all sofa sizes will depend on the size of its base.
Next follows a sofa back, which should have a small slope for convenience. In this embodiment, the sofa frame of the back consists of four vertical and two horizontal boards with a thickness of approximately 30 mm. The height of the sofa is also free to choose themselves, based on their preferences and opportunities.
Next, plywood is superimposed on the back frame. It is overlayed on the entire plane from behind, and only on the open upper part. The bottom then closes the seat.
Article on the topic: We make a panel into the kitchen with their own hands
Phaneur follows from all sides to Vatin. After that, you need to connect the base with the back.
After the size of the folding seating is marked, you need to start assembling its lower part, which consists of three short and two long boards. One of the three boards will be in the middle of the seating in order to increase its rigidity and reliability, as well as it will form two compartments inside the sofa. The bottom of the seating is also made from plywood.
The resulting design must be seized with a cloth that will be attached to a construction stapler.
Then it must be installed on the base and secure the base itself and the sofa back. The upper part of the sofa should be made of thick plywood and a rather thick layer (about 20-25 cm) of the foam rubber. Fanoire with foam rubber should also be seeded with cloth and then secure the top of the seating to the bottom with the hinge.
Here is your sofa and ready.
At the same time, you needed a minimum of tools that will always be found in every person who loving do everything with their own hands.