The envelope for the disk will perfectly preserve the carrier in proper condition, will allow you to save its delicate surface from shocks, scratches and other possible impacts. Such a carrier is a guarantor of information saving. For example, now everyone has digital cameras and a large number of photos. Print all of them is not possible, it is very expensive, and it requires a lot of space to locate albums. Therefore, the carrier in the form of a disk is a reliable option for the safety of memorable events. In this material we will deal with how to make an interesting envelope for disk with your own hands.
This article stages will present the creation of an exclusive envelope under the disk, which is suitable for photos of any event, including weddings, birthday, New Year.
From paper for scrapbooking
Paper for scrapbooking - Wonderful material for performing unusual products. Scrapbooking technique itself gained its popularity for the ability to do even inexperienced needlewomen and without special tools.
Material for work:
- For the foundation, dense paper is necessary;
- Scotch with bilateral fixation;
- curly holes;
- line;
- scrapbook;
- Knife stationery and scissors;
- Details for decor: beads, ribbons, minor pearls.
Go to the master class. On the selected dense material, using the ruler and the stationery knife, the basis of 15 × 29cm is performed. The envelope itself will have a size of 15 × 15 cm.
The size of the envelope can be diverse at the discretion of the Delta, but it is worth considering that the disk should not ride and not be compressed.
The base is folded in half on a thin and flat line. For flexion of dense material, it is better to use a non-sharp object. Paper for scrapbooking will serve in the design of an envelope. The size is less than the foundation by 7-8 cm, the square is cut. To give the raisher, the lower corners are cut with figured scissors. On the envelope you can arrange several butterflies, their contours are performed using a special contour hole panel. To create the effect of "living" butterflies, wings are lifted. Using the griffel, the pencil is made toning the edges of the envelope and the wings of the butterfly. It should be monitored so that the drawing performed is uniformly and equally.
Article on the topic: Cozy candlestick from banks with their own hands
Decorative and interior decoration
It is necessary to take multicolored and unequal three satin ribbons in width. The length of the material is equal to the length of the side of the envelope with the addition of 3 cm. On the scrapbook on the bilateral scotch, the wide tape is initially glued, after which it is fixed narrow.
In the middle of the envelope, 2 more small tapes fixed with scotch and tied to a bow are harmoniously located. For expressiveness, you can arrange several beads on it. The template is located below.
To save the disk in the inside of the envelope, a pocket made from scrapbooks carved in the form of a rectangle will be located. One corner of the rectangle is performed by scissors in the form of a semicircle, and the remaining 6 mm is wrapped inward. This will keep the disk firmly.
With the help of a crushed pencil, the pencil is made toning the rounded edge. Two-sided adhesive glands glued to the curved edges of the rectangle and fixed on the right side of the envelope. In such an envelope, another disk will fully enter. To do this, you need to repeat the previous steps only for the left side.
Square made of decorative trim, glue on the front of the base. And everything, the envelope is ready.
Kraft paper
For cases when there is no time to create a chic decorated envelope, you can perform simple envelopes from craft paper.
Material for work:
- kraft paper;
- pencil;
- line;
- contour holes;
- glue or bilateral tape;
- scissors.
Description of the stages of work:
- On kraft paper, using a ruler and pencil, a sketch of the future envelope is sketched in the deployed form. Figure below is a good pattern;
- With the help of scissors, the harvested image of the envelope is cut and folded along the contours to make the envelope;
- The parties of the envelope can be copped with bilateral scotch tape or glue;
- In order for the envelope to be not opened, and the disk did not fall out, it follows to fix the closing side. For example, you can on the envelope under the closing part with a curly hole to make a heart, and on the "closure" to perform a slot. In the future, you can stand heart and stretch through the cut line. Having straightening the heart, you can get a small but reliable clamp.
Article on the topic: Brooch do it yourself - master class
- For the decoration of the envelope, you can use the grimged pencil tray, crawling it around the edges of the envelope.
Unusual, but rather simple and affordable tunes of paper ready.
This envelope is convenient to perform disk content entries. It is thin enough and does not take much space when stored.