Fliselin wallpaper is the most popular finishing material. The high demand for this type of canvas is related to the fact that they are comfortable in terms of sticking and care. Compared to traditional paper wallpaper, phliselinic possess many advantages. In addition, this finishing material is not smeared with glue, and this greatly simplifies the process of pasting. For the correct installation of the wallpaper, you need to know the main points of this procedure, and the skill is already appeared after sticking the first canvases. So why when sticking wallpaper Fiz Flizelina do not need to smear the canvas themselves, let's understand.
Cooking the walls to stick flizelin wallpaper
Why not need to smear
The range of the presented wallpaper products is enormous today. There are wallpapers that smell glue in front of their fasteners. They must not swell, otherwise they cannot be glued or after some time they will dug themselves. But phlizelin wallpapers do not require compliance with this item. All that is required of you is to measure the size of the canvas and smear with glue only the wall.
At the same time, you must ensure that he does not have time to dry before sticking the finishing material. For this reason, the glue is smeared either in two layers or pre-treated the surface with a weak adhesive solution.
But before sticking, it is recommended to carefully examine the labeling on the roll. If you see an icon with a brush that has a parallel location to the wall, this indicates that the glue is smeared directly on the wall. When the brush is depicted parallel to the horizontal plane, the adhesive composition is distributed on the web.
Designations on the wallpaper
If you use the canvas on a paper basis, then the glue is not on the wall, but on them. While you will miss the web, they drink, swell, and the deformation is missing after a sticking was performed. If the adhesive composition is already distributed on the wall and attach the material on a paper basis, they will begin to swell directly on the surface, folds will begin to form, and under the wallpaper air bubbles. In the assortment of stores you can see self-adhesive wallpaper. On their reverse side there is adhesive impregnation. It is enough just to sprinkle with a canvas with water and start shook.
Article on the topic: How to fix: a handle near plastic doors broke
The process of applying glue
Before sticking wallpaper, it is necessary to determine the type of glue used. It is best to be guided by the instructions that are available on the roll of wallpaper. There manufacturers indicate the brand of adhesive composition optimally suitable for the selected type of finishing material. The process of gluing cliffs on a flieslinic basis should occur only under the condition that the surface of the wall is clean.
If before this, the paint was used to finish the walls, then it is first necessary to sand it, and then rinse with special detergents. Then rinse the walls with clean water. Wait until the surface dry out the surface. It is from the correctness of the preparation of the surface will depend on the adhesive of the considered canvases.
It is very important to qualitatively prepare walls under the wallpaper
Be sure to completely eliminate the previous wall finish. If absorbing surfaces are present, such as wood, gypsum, drywall, then it is necessary to pre-apply primer solution on them. To prepare glue, you need to take a bucket, pour 5 l of water intended for sticking of the weeds under consideration or 4.5 liters of cold water for cloths intended for subsequent staining.
When water is thoroughly mixed, smoothly add adhesive flakes or powdered composition. Leave them for 10-15 minutes, and when the flakes will scatter, then mix them thoroughly.
Now you can proceed to sticking fliseline wallpapers on the wall. According to the technology, only the finishing surface is smeared. Before performing this condition, from the window or open door, you need to portray a vertical line, the length of which is 50 cm. Thanks to such tricks, it is possible to accurately determine the location of the cutting cutlery at the door of the door box. On the surface to distribute glue using a roller. He must have a small length. You can use a wallpaper brush. The process of applying the wallpaper glue should occur along the previously depicted line.
Works on the Wallpaper Wallpaper
It is important to understand that the phlizelin wallpaper does not smear glue. Distribute glue not only on the roll width, but slightly increasing the area on both sides. Be sure to carefully treat all the corners and places along the plinth. To do this, use a small tassel. If the phlizelin wallpaper was crucified correctly, according to technology, then notice that they are dug, it will be impossible.
Flizelin wallpaper can be glued with a roll or pre-prepared strips of the required size. The first way to better use those who have been finished with fliseline canvases.
When phlizelin wallpaper was attached to the wall, it is necessary to carefully smooth the surface, moving from the middle to the edge. During smoothing, you must remove the accumulated air bubbles. Using scissors, denoting the lower fold located along the plinth, cut it off. But to perform it only after the flieslinic wallpaper can carefully.
Article on the topic: What self-leveling bulk sex is better: mixtures and brands, reviews and what to choose for an apartment
Although the flieslinic wallpaper should not be smeared with glue, the process of their blowing is no less responsible than when finishing with other canvases. If you do not comply with the technology and make your additions, you can eventually repair again with time, since you will notice that your canvases are dug.