There are situations where the electric kettle is out of order, and the person is in the country or simply lacks the ability to buy a device that will heat the water. With such a situation, every person may face, but the output will not find any work, because the heating device can be done with their own hands. In this article we will tell you how to make a boiler at home from girlfriend.
Boiler from kettle
- Ten from the kettle. It can be pulled out, there are no special difficulties in this.
- Two-tissue wire with a fork. By the way, it can be taken from the kettle.
Procedure:
- Pull the tan from the kettle. Do it stands carefully, so as not to damage it.
- You need to fix the wires. This can be done with a soldering iron, although it is better to use cage blocks, they are distinguished by their reliability. How to do it all see photos.
Please note that initially you must perform a heating element call when the wire is not connected to it. Next you need to check the already connected device. If everything is in order, then you can safely use the homemade boiler.
Remember! The device is self-made and not quite reliable, so you need to constantly monitor how it works. If something happens, even overvoltage protection vehicles may not be saved.
How to make a boiler from blades
Now we will tell about a dangerous way. Here, be careful, in the following cases it is impossible to use such a boiler:
- If you warm the water in the iron container.
- If water is salted.
The listed cases are the danger to the body, because it can strike the current.
Also pay attention to the fact that with the help of such a boiler, water is not worth heating for tea. If you need hot water so that you can buy, then it's better not to come up with.
Article on the topic: Living rooms IKEA - 100 photos of the best models from the 2019 catalog
We collect a boiler from the blades step by step and with the photo:
- Initially, you need to take: wire with a fork, two blades, threads, matches.
- We clean the wires of the wire and screw them into the blade. For confidence, the mount can be soldered, then the design will stay perfectly.
- We associate 4 matches between themselves (two pairs) threads, it is necessary so that the blades do not come into contact with each other.
- The whole design of each other is also associated with threads. Watch the photo, how to do it.
Connection diagram is as follows.
And so you can warm the water with a homemade boiler.
Please note that on such instructions you can make a boiler from the following materials:
- Bolts.
- Spoons.
- Nails.
- Metal plates.
- Knife
The main condition is to ensure the absence of contact, otherwise avoid short circuit.
We also recommend to see this video on homemade assembly.
Proper generators or how they are deceived.