Sports and gyms to the outdoor coating are subject to special requirements. First of all, this is the absence of danger of injury and environmental safety.
People in such premises are subjected to intensive loads, the body is losing vigilance and becomes more prone to different negative effects, so health safety is also very important quality of any finishing material.
Property features
All necessary properties have a regus - flooring produced from high-quality rubber granules connected by polyurethane. This material does not distinguish any harmful substances into the air and does not slide, which makes the regus perfect sex for any sports room.
In addition, it can be laid on open playgrounds and stadiums, for example, to cover treadmills, as it is resistant to all atmospheric influences.
Regus has other advantages:
- Durability - the very first installation procedure was carried out in the 1970s, and now, several dozen years later, this coating still remains in excellent condition;
- incompetence of rotting and decomposition;
- In such a floor, bacteria, fungi and insects are not multiplied;
- antistaticity and hypoallergenicity;
- resistance to vibration and mechanical damage - impact, abrasion, puncture and cuts;
- good sound insulation indicators;
- Easy installation and neutrality to care.
These quality material allow us to give the gap outstanding safety indicators. It is worth noting that the operational properties of the regulation are not lost throughout the service life. Even a dozen years of intensive use, the floor cover will be as new.
Scope of application
This material is usually used to finish floors in various sports complexes and on open areas. At these objects, the regulators are used as an elastic substrate of multilayer finish flooring, as well as an independent flooring.
Article on the topic: Are the balcony or loggia by general
Thanks to its impeccable properties, this material may have another purpose. For instance:
- Substrate for absorbing noise and vibrations when finishing floors, ceilings and walls.
- Use in construction as protection for waterproofing materials and concrete. In addition, this material can be used to protect roofing from water, especially soft roofing materials. Concrete is protected by regus if it is necessary to place heavy equipment on concrete floors during the construction of the building, capable of damaging the design by its weight. Also, the regus absorbs the vibration from the operation of the equipment, which also has a positive effect on the state of concrete surfaces.
Properties of regipol
This floor covering has the following specifications:
Such properties provide the versatility of the material and the possibility of its laying in almost any operating conditions.
Installation of regupol
Mounting technology of this coating is standard and consists of three stages.Surface preparation
Like all floor coverings, the regus is laid only on a carefully prepared surface. This is especially important for soft and flexible materials, since they appear on them all the flaws of the grounds, and this finish option does not become an exception. Make the surface of the base perfectly smooth and suitable for laying the regulatory by two methods:
If the base is concrete, the alignment is made by constructing cement-sand or gypsum screed. Minor irregularities can be fixed with a fill of the self-leveling mixture.
The wooden base is straightened by cyclishing, fitting the floorboard or decay of sheet lumber - plywood, chipboard, osp.
Be sure to close all breakdowns: cracks, chips and potholes in concrete, cracks in the tree. In the first case, the surface must be covered with primer in two layers. To do this, a mixture of glue and turpentine in equal proportions is made, applied to the entire floor area and dried for half an hour.
Article on the topic: Modern ceiling backlight LED ribbon
Application of glue
The adhesive substance is applied to the surface of the base, and not on the coating itself. It is recommended to use a special two-component glue based on polyurethane, it is better suitable for elastic coatings.Laying
Wait until the glue does not need it. Usually, the procedure is performed in parallel - the glue is first applied, and immediately the rolon of the regulatory is stacked on it. To stick the rubber canvases are tight. On the perimeter of the room, the coating is fixed with plastic or wooden plinths.
It is allowed to use regugol on floors equipped with warm floor systems, in which case, heating elements should also be installed before the coating is also needed.
It is possible to use the regus with water, and with infrared, and with heating cable systems, since the coating is resistant to temperatures in the range from -50 to +70 degrees, and, if necessary, withstand all +120 degrees. This allows not to worry about the damage of the regulation, even when covering it the most powerful heating system.
Possible breakouts of pipes in the water semi are also not scary to rubber coating, since no component of this flooring is afraid of moisture.