[Will clean!] How to effectively clean all the cranes in the apartment?

Each hostess at least once in his life came across the problem of cranes from limestone plates, but rarely who thinks about the reasons for his appearance. The thing is that water entering the apartments contains a large amount of mineral impurities and chlorine . The level of impurities and chlorine in tap water can vary significantly depending on the area of ​​residence.

But in any case, such water has an unbearable harm to mixers and other water supply elements. Therefore, many owners are concerned about the constant question as efficiently and without harm will punish limestone flare on the cranes? Today there are quite a large number of different methods, and now get acquainted with the most popular ways.

Tips for sacrifice crane from plaque

For high-quality cleaning of plumbing from a well-known land, it is recommended to comply with the following recommendations:

1. You should not use metal sponges for cleaning plumbing, since scratches that are formed after that, it will be impossible to remove, well, of course, if you do not completely replace the mixer.
2. Choosing an optimal tool for cleaning, you should not use a variety of abrasives, they strongly spoil the surface of the crane.
3. In a situation where there is phosphoric, sulfur or hydrochloric acid in the detergent, it is better not to take this means in hand. Since these acids adversely affect metal, and can lead to the cause of rust, yellow spots that are problematic.
4. In addition, it is not recommended to mix various detergents among themselves.
5. It is best to choose the means special for cleaning plumbing, then the risk of getting damaged on the tap is minimal.

Article on the topic: [Will be pure] How to wash the bath from plaque and rust?

All presented recommendations must be observed, otherwise, all damaged mixers will have to be changed.

The best folk remedies for cleaning plumbing

Coca Cola

Almost immediately, as this drink appeared on store shelves, smart hostesses found out that it was not only a wonderful drink, but also a useful thing in the house. With it, you can easily remove the limestone flare from any mixer. It will only be enough to wet the crane of this stormy mixture, wait a bit and you can safely remove the plaque with a napkin . Such an action occurs due to a large number of acids included in the composition, so such a means should always be in service.

Baking soda

What would be convenient to apply soda to the crane, you can use an old toothbrush or any other. Soda need to rub the surface of the plumbing. After you need to neatly rinse with water or wipe the mixer with a soft napkin. If necessary, you can repeat the procedure.

Salt

Quickly and easily cleaned the surface of the crane using the cook salt. Salt gives the part of the shine and, which is important does not leave after the divorces. To do this, it is necessary to make salt crap to apply it to the mixer, evenly distribute the crane and wait for 20 minutes, after rubing the surface and admire the frequency of the tap.

Any toothpaste

For this, the means to take the usual toothpaste and several cotton disks. To cleaned the faucet, you need to squeeze the mixer on the surface of the mixer on the surface of the mixer and take it carefully with your cotton disk, leave for 5 minutes and wash off with water. This is a fairly simple recipe that will eliminate the fallow from any surface.

Lifehaki, how to quickly and easily clean the nickel-plated crane (1 video)

Chitka and washing the crane in the kitchen and in the bathroom (7 photos)