How to refresh the old fridge?

Many people had such a situation: renovated in the kitchen, and the old refrigerator does not fit into the overall design. It works well, spacious. Throw out a sorry or there is no money to buy a new one. How to give a second life to the refrigerator? The exit is, modern materials and technologies allow you to make a technique for any interior.

Make Decoupage

This is not a time-consuming case, but accurate, patience . There are space for fantasy. What will take:

Multi-layered napkins with a pattern or ready-made sets;
scissors;
PVA-glue;
Tassels: flat natural and thin from synthetics;
Pencil styling;
Acrylic paints;
varnish.

Preparation of the surface: Declaring alcohol if there are no damage, paint. Wait for complete drying, then separate the napkin with the pattern, cut the desired item. Make the required number of blanks. The next action is to glue the first part. Further, smear the opposite side with glue, attach to the place and carefully smooth out.

Flush and folds to clean the tassel, excess glue with rifle, waving movements. Thus, proceed with other billets. You need to move from the middle to the edges. When the picture has developed - draw the contour of the elements. Next to cover all two layers of varnish with intervals. It turns out a robust beautiful surface.

Paint an old technique

Serving a lot of years the unit sometimes looks slightly fenced. Here you can give the refrigerator freshness with paint.

It is necessary to cook:

Scotch.
Sandpaper.
Paint.
Roller

Before the color you need to prepare the surface: Wash, unscrew the accessories, if it is impossible - stick the handle with adhesive tape . Light movements to handle the skin surface. It is possible to paint the fridge using a roller or spray. Work is subtle, requiring patience.

Article on the topic: Retro Chuck Norris: a review of the star mansion for 1.2 million dollars

Important! It is necessary to cover evenly and smoothly, a thin layer! The first pass looks a little unclean, which can scare. It's not necessary to be afraid when the paint dries away again. There must be 4-5 layers. After completing the work, remove the heights on the inside of the doors.

Stick film or magnetic panels with photo printing

You can give the refrigerator any kind: the English telephone booth, the car of the carbonated water from the USSR and so on. All this will make a vinyl film or a panel with a magnetic surface. Both materials protect well refrigerator from damage, contaminants and give aesthetics item.

For work you need:

hairdryer;
alcohol solution;
bank card;
stationery knife.

Film with photo printing is usually glued using a home hair dryer. It spreads warm air, as a result, a minimum of bubbles and an excellent gripping with the surface. First you need to wipe the refrigerator with a degreasing fluid. Disassembled handles, other protruding elements.

Then, the film starts to remove the protective layer and are simultaneously glued to the surface. On top down smoothing bloat.

Tip: For better effect and convenience, you can drive bubbles by a bank card. The edges of the film are adjusted, smooth. Excess material to trim the sharp knife. At the end, fasten the accessories into place.

Magnetic panels look like elastic plates. They are made of vinyl - a thickness of 0.5 millimeters, with a magnetic surface and photographic printing from the front side. The view is huge magnets made under the size of the refrigerator, approximately width - 70 centimeters. Thus, they decorate mostly the front door, although you can salary and sides. These materials are perfectly removed, do not leave sticky tracks.

The renovated refrigerator will serve for a few more years, will play with new paints . An exclusive thing appeared, which can be booked before the guests.