Probably every dacket wants to make an inexpensive bed for giving with their own hands. For the manufacture of beds, we will need a minimum of tools and material, and in time it takes about 3-4 hours. The bed is easily going and disassembled as a designer. That is, it can be easily transported in the car in the case of moving.
For the manufacture of the bed we will need:
- Frame board, 30 mm thick;
- board for flooring 25 mm;
- log;
- screwdriver or screwdriver;
- burner;
- electrolovik;
- clamps;
- Fastening elements.
Well, they prepared tools and materials, it means you can start making the bed.
But first we will define the size of the bed. It will be right to buy the mattress of the desired size, and already to make a bed under it. If you do vice versa, then in search of the desired mattress size, you can spend a lot of time or you will have to order an individual mattress, which will be much more expensive.
We take cooked boards and make the markup already on the purchased mattress.
Take the marks on all boards, so that one board entered the second, as shown in the photo. Such a fastening will be quite reliable and does not require any additional fasteners. Here the main thing to do was not too wide, but by the size of the board.
Install the board into the board. Perhaps it will take a hammer for this.
As a result, we should get a frame of bed for giving.
To the long sides of the skeleton of the bed, the supporting boards, which will be laid down from the board, and already on him the mattress. For work, we will need a screwdriver and if you make an assembly yourself, then clamps.
The reference board is attached with screws in 15-20 cm increments.
The floorboards of the flooring should freely go to the supporting board.
Nastya bed is ready. In this case, wide boards are applied, but you can also use the board for already.
Article on the topic: We make a podium for the shower cabin with their own hands
For the manufacture of legs, we will use a log thickness of 15 cm and a length of 60 cm.
The log need to cut into 4 equal parts and make cruciform drank, as shown in the photo.
We try on the legs to the bed frame.
The legs need to be trimmed on one side so that they are tightly fixed on the bed frame.
After installing the legs, it is necessary to cut the main frame boards.
Frame frame with legs ready.
We put the wooden flooring.
It is the time of the bed decor. We will do everything with the help of a gas burner. We work carefully, so as not to burn our wooden bed.
As a result, we have such a beautiful burnt bed for giving. The mattress and bed remained.