After the door frame is installed in the opening, the next step in the decoration should go to the installation of the batteries of interior doors around the perimeter. We call the decorative element of the door interior, which closes the available between the wall and the door box. They are needed both for inlets and for interior doors so that their appearance has been completed.
Prints are a decorative element of the door interior covering the doors between the wall and the box.
To install, you will need:
- wood hacksaw;
- platbands;
- roulette;
- Corolnic;
- level;
- Special counted nails without a hat;
- Glue or liquid nails.
In the form, framing doors, the bar can be different, the classic is considered flat. They are neutral enough in appearance and are suitable for any interior, so enjoy great popularity. Rounded rounded frontal part, which gives the straps a little unusualness and is not suitable for each interior. The most elegant - various types of curly planks. Their use of individuality and unusual interior.
Diagram of installation of door platbands.
Multiple materials are made from several materials, but the most common is wooden. They are done using profile milling of planks or applying massive wood with different patterns. To exclude defects and reduce the cost, make such planks from the split through the length of the wood. From the best of wood quality, semicircular strips are manufactured. Plastic most often flat and made of PVC, and metal aluminum or steel. There are also door planks made of composite materials such as plywood or MDF with lamination.
Preparation of the installation of platforms of interroom doors
The mounting of the slats is made no earlier than the indoors completed the wall decoration and the doors are installed in their box. Otherwise, the place of the joints can be very noticeable.The platbands are attached according to the height of the doorway, simultaneously with the installed platbands are determined with their length. For this, the platband is placed on a solid flat plane, with the use of the coal at the end, the straight angle is drawn, unnecessary cut off, without waiting for the installation.
Article on the topic: Cork wallpapers in the interior: Photo, for walls in Lerua Meren, Substrate, reviews, Is it possible to glue on the wallpaper for a plug, how to glue, video, glue, technical plug, photo
General installation scheme of the door leaf, boxes, dogs and platband.
The unfolded platband is applied to the interroom box, once again aligned at the bottom, upstairs and at the edges, the height is noted equal to the inner corner of the door frame.
From the resulting mark with the help of the salt, an angle of 45º is carried out, along this line, the platband is reflected and deposited to the side. The same procedures are made with the rest of the interior doors. Mandatory condition for high-quality installation is the markup and trimming of the upper platband last. This allows you to smooth out the markup errors when installing, as the upper part is placed on the right and left, taking into account their possible curvature.
Installation of trimming
After the lateral platbands are cut off, it is necessary to start mounting from the preparation of nails.
If these are ordinary nails, it is required at the angle to bite off with their caps and score into the door frame.
Outside, each nail is left so much so that there is enough to pass the platband through or not reaching the surface of 5-6 mm. 1 nail is clogged from above, 1 in the middle and 2 more from the bottom. A thin glue band is applied between the nails so that the box of interroom doors and the platband begins better. The glue should not get out when they are conversible.
The bar is needed, which will be a gasket, it needs to be wrapped with a cloth, since it needs to be hit by a hammer, attaching a platband on the nails sticking in the ends of the door frame.
Both the fabric, and the bar are needed to soften the blows and that there were no traces from work on the platband. The tree is thoroughly aligned with applying, then the hammer is saturated with strong and fast movements on the prepared nails. In the work you need to remember the correctness and uniformity of the location and, if necessary, to make amendments.