How to make a soldering iron do it yourself

Many people are interested in how to make a soldering iron with their own hands from the girlfriend, so we decided to delve into this topic in more detail and tell a really working way. It is worth noting that every person can make a good soldering iron, in this article you will find step-by-step instructions and several video examples.

How to make a soldering iron do it yourself

So, to make a soldering iron with a thin stress, we need to collect basic materials. As a rule, they can be found in the garage, if not, then the nearest market will definitely help you out. We decided to tell the easiest way, for this you will not need to spend much. We stopped special attention on the fine core of the soldering iron, because it is not enough for many electricians, and the old one is not always convenient and appropriate. In another article, we did a drill of the girlfriend, it will also be interested in reading.

These are the materials you need to assemble:

1. Ball handle.
2. Resistor MLT-0.5, its resistance should be 5-10 ohms.
3. Two-way textolite - 10x30 mm.
4. Steel wire with a diameter of 0.8 mm.
5. A small piece of copper wire with a diameter of 1 mm.

   

Step-by-step instruction

If you only follow the way it is written - the soldering iron do it yourself from the resistor to do it. The way is not a difficult even the child can cope with it without much effort.

1. First of all, you need to remove the paint from the resistor's surface, you can use a regular knife. If it smelled too badly, then connect the resistor to the power source and warm it up.
2. We prepare the barrel, two wires come out of it, one must be cut off. In this place, drill a hole under the copper wire, its diameter is 1 mm. Remember, the wire should not touch with a cup, for this make a razing with a bigger drill, like this looks like this. In the end, we make a small propyl for a toxide on a cup of resistor.

   

3. We take a steel wire and strifting it in the form of an ordinary ring. The diameter must match the cutting on the resistor.

   

4. Their two third-party textolite needs to be filled with a fee, like this looks like this. The size is focused on themselves, because the size of the handle and your wire can differ slightly.

   

5. We collect everything among themselves, the homemade soldering iron at this stage does not cause any difficulties.
6. We establish a subtle sting of the soldering iron into the landing place. Here be careful, the whole design can be buried. So that the wire from copper has not burned the resistor make a protective layer using a piece of mica or other material that you have at hand. Learn how to make a PC in a car.

   

   

7. Ultimately, you need to connect homemade soldering iron to the network. To do this, you can use the usual power supply to 1 A. Remember, the voltage should not be more than 15 volts, if 12 is also suitable. In this case, more does not mean better.

   

Article on the topic: How to make a greenhouse or a greenhouse with your own hands (16 photos)

Here we are with you and disassembled how to make a soldering iron with your own hands from the handle, a resistor and wire, as you can see, there are no special difficulties. But, to show certain skills will have to.

But, even despite this, everything, buy a soldering iron of this type is much simpler, it is not worth a lot of money. So before starting to the assembly, think well, it is worth it or not.

Soldering iron with your hands video

Here is another great way.