Every person living in the apartment always worries that not to flood his neighbors. In this matter, even high-quality and inexpensive plumbing can always come to the rescue. As a rule, water falls into the floor randomly and no one even notices her until neighbors are resorted to a check on the repair of their ceiling. In this article we decided to tell you a great way that will help get rid of such problems. Here we will tell you how to make a water leak sensor with your own hands from simple materials and consider step-by-step instructions.
Water leak sensor materials
To make an aquastoxt, with your own hands, you need to collect the following materials, find them there is no difficulty, most expensive from this list is a bottle that will have to buy (if you do not have it). So, we need the following materials, we recommend that your fantasy does not show and buy everything strictly on the list:
- Three volt batteries, you need to use CR1632.
- Transistor BC816 or BC517 with NPN dialing.
- Resistor 1-2 megaoma.
- Pedia emitter with generator.
- Protection against water leaks do it yourself
How to make a water leak sensor with your own hands
So that we manage to make the water leaks signaling device with your own hands you need to follow the following instructions, there are no special difficulties in such an assembly, there are features and secrets that you will learn about. Initially, see the scheme so that we can make the water leak control system without problems. Learn about how to make a solar battery for charging a mobile.
Step-by-step instruction:
- We solder a resistor to piez.
- Next, connect the transistor.
- We connect batteries, fastened only on the blue isolate, only it can give the result.
- We make the body for our water leak sensor with their own hands, cut off the neck with a big bottle. Do not forget to do the bottom, for this you can cut off any side from the bottle and attach it with the help of hermetic glue, if desired, you can even heat. It will be interesting to know: the control do it yourself.
- We make two holes to insert the case.
- We take the lid and make holes for piez, because of such a hole and sound will appear.
- Close the lid.
- Check how everything works.
Article on the topic: how to remove old linoleum: dismantling rules, tools, recommendations
Outcome
Such a homemade can be installed:
- Under the sink.
- Washing machine.
- And in any other place where it will seem needed.
It will be turned on only if the water fell on the housing. So, you can not even worry about the fact that with time there can be a battery. Sound, which she will publish should have enough, and all people located at home will immediately notice the leakage and can prevent it in time.
Similar article: how to make a projector for mobile with your own hands.