If the centralized gas supply is missing, heat water and cook food is used by gas speakers and plates capable of working on a gas cylinder.
What gas in cylinders?
A gas cylinder used to heat the water contains such gases as propane and butane. They are by-products of oil processing, gasoline and gas. In the cylinders there may be only a technical butane or a mixture of butane and propane, which happens summer and winter.
Compressing these gases converts them into a smaller fluid (and therefore such gas is called liquefied), and with a decrease in pressure, this liquid begins to move into a pair state. Since the temperature increase causes a strong expansion of liquefied gases, the cylinder is usually filled by 85% of its volume, so there is always a layer of vapor gas over liquid gases.
Why are often used in the country?
For giving a heater selection that uses gas from a cylinder as an energy source, often acts as the only possibility of hot water in country conditions. In situations, when the main gas pipeline is not supplied to the country, and there are problems with the power grid, the gas column of this type will become a real salvation.
Consumption
When the water heater connected to the gas cylinder, an average of a single gas cylinder with a capacity of 50 liters is enough for daily minimal providing hot water of two or three people during the month.Connecting to a cylinder with liquefied gas
First of all, you need to make sure that your gas column is configured to use that gas that is present in the cylinder. If required, performed by reference to the column with replacing the collector nozzles and the tightness assessment of the compounds. At the same time, on the equipment, be sure to noted the date of the reconfiguration and the type of gas that can be used in the device.
The balloon that will be connected to the gas column must be equipped with a gearbox with a stabilization pressure of 300 mm water., As well as the minimum performance of the steam phase 1 m³ per hour. Also pay attention to the selection of the hose - its length should be up to two and a half meters, and the inner diameter must be from 12 millimeters. It is important to purchase a hose that will withstand work with a column on the gas cylinder.
Article on the topic: Choose interior doors of the color Anegri: species and colors
When installing the hose, it is impossible to be engaged and twisted. If the hose has to be installed with a bend, for this use adapters and follow the bend radius (it should not be less than 90 mm on its external drawing). In addition, the hose should not bend within 50 mm from the ends of the tips.
Installation of a shut-off gas crane must be carried out in front of the column so that it is easy to get to this crane. After completion of the installation work, the hose and other connections should be checked for timely detection of leakage sections. Only after that, the column can be used to heat the water.
