Make a rack for a bike with your own hands
There was a need to do bicycles. Configure switches, brakes. In general, planned.
In the area, it was not possible to find a bicycle rod, go to the usual place of bicycle fuses - Sokolniki - far away. By car with two bikes hemorrhoids. Its move is even greater hemorrhage.
In short, what's difficult there? All these settings can be done yourself. It is only necessary to post the rear wheel.
So, given:
1. Two bikes waiting for them to take up
2. Two half-and-half pieces of reinforcement 10.
Hit!
3. Using the homemade bending machine is done - once. Because of the minor, the machine, with such a double fiction I had to tinker.
4. Next, I extend the top of the arc. It had long and hard to adjust the loyal angles in two gospels. There were no drawings, everything is done on the eye. It was necessary that these bends in the final product were strictly vertically.
5. fitting, fitting
6. It seems to be clearly
7. Extinguish the deflection at the bases to stand on 4 points, and not on the 2nd strips.
8. ready for welding!
9. Cooked.
10. Installing the bike goes at the expense of ears clinging for the trunk. It was the most universal scheme for two different bicycles. The nut and eccentric was not fixed, too different landing places.
11. Handed perfectly. Locking dead, no bouncing and offsets.
What if the bike is without a trunk? Well, these two are always with trunk.
12. Excess now I will sink
13. Voyali!
14. Reduce the width of the ears. So easier is inserted where it is necessary.
15. Everything is ready for repair. I will not paint.
Article on the topic: Places where you can store shoes